Minn Kota Ulterra Deploy Problems - Gen 1 one or gen 2 matters as to what kind of problems they have. Gen 1's have an issue with the magnet sensors where the magnets can fall out or shift and cause it to act. If this is the problem, you need to go up to the tm and push it forward in the ramps (it will only move a half inch at most) before hitting deploy. Then, if it deploys. that's your. To help the mechanic better understand your situation, could you please confirm the year of your minn kota riptide ulterra? Take some degreaser to it, get all the gunk off of it (worm gear). Spray some corrosion x on it then stow and deploy it a few times to lube it up. If the shaft of the trolling. Have a minn kota ulterra. Late in the season the motor started doing something weird. When i deploy the motor, it is rough and almost uncontrolled. It quickly flies up about. Itโs a pain to manually deploy your trolling motor when you are offshore and itโs lumpy but it beats having to deal with an ulterra that will not stow when your 25 miles offshore. Over the weekend the ulterra paused while stowing. I bypassed the reset and manually stowed the engine. I mistakenly hit the deploy button while the lever was.
Gen 1 one or gen 2 matters as to what kind of problems they have. Gen 1's have an issue with the magnet sensors where the magnets can fall out or shift and cause it to act. If this is the problem, you need to go up to the tm and push it forward in the ramps (it will only move a half inch at most) before hitting deploy. Then, if it deploys. that's your. To help the mechanic better understand your situation, could you please confirm the year of your minn kota riptide ulterra?